Kyoritsu 5000 Instruction Manual Manual de usuario descargar pdf (Pagina 16)

―

Step4: Start of recording

Follow the procedures stated below and start recording.

Be sure to check each setting before starting a recording since the

settings cannot be changed during a recording.

1. Press down the button for a while.

At continuous recording mode or after

changing the recording mode; "CLr"

flashes while the button is being

pressed down. A few seconds later, the

measured value and the "REC" mark

are displayed on the LCD. Then a

recording starts.

(The data, which had been recorded,

will be cleared at this time. So the

important data must be transferred to

PC in advance.)

At Event/ Max value/ Capture recording

mode or the recording mode is not

changed, the "REC" mark flashes and

the measured value and the "REC"

mark are displayed on the LCD. Then a

recording starts.

(At these recording modes, recorded

data will not be cleared when continuous

recording is performed. The recorded

data will be deleted when changing a

recording mode or sensor connecting

channel. So the important data must be

transferred to PC in advance.)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Sin comentarios

Kyoritsu 5000 Instruction Manual Manual de usuario Pagina 16