Kyoritsu 5020 Instruction Manual Manual de usuario descargar pdf (Pagina 18)

* Settings cannot be changed during recording. Carefully check the

settings prior to a recording.

* Previous recorded data is cleared and new recording starts when

changing the followings and starts recording. (In this case, "CLr" flashes on

the LCD at a start of recording.)

1) Recording mode is changed.

2) CH for Sensor is changed.

3) Sensor type is changed.

* Transfer important data to your PC first and clear Memory (P.33) since

further recording isn't activated when all the 3 blocks in Memory Block

(P.15) are full.

* Follow the procedure below to start recording.

1. Press down the button at least 4 sec.

" " or "CLr" mark flashes. Keep the button

pressed down until " " mark lights up.

Recording stops when the button is released

while the mark is flashing.

2. Measured value is displayed and " " mark

lights up, then measurement starts.

◆

Additional three recordings (Memory Block /

see the next page) are possible.

In this case, one-time is automatically selected

and recording stops when memory becomes

full.

◆

It is recommended to clear the memory before

starting to record if previous data is not

necessary.

Step3: Preparation before recording

↓

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Sin comentarios

Kyoritsu 5020 Instruction Manual Manual de usuario Pagina 18