Kyoritsu 5020 Instruction Manual Manual de usuario descargar pdf (Pagina 31)

◆

Flashing Detection LED

●

LED on the Sensor connected channel blinks when following Trigger

is detected.

<On KEW5010> Trigger is detected when the measured values

exceed the pre-set detection level under Trigger/ Capture Recording

Mode.

<On KEW5020> Trigger is detected when the measured current

values exceed the pre-set detection level under Trigger/ Capture

Recording Mode and Power Quality Analysis Mode.

For voltage values, Trigger is detected when it is below the

detection level.

●

LED flashes whenever the measured values exceed the pre-set

detection level during measurements.

●

LED blinks every 4 sec during recordings after one detection

occurs. (When Auto-power off is OFF, it blinks every 2 sec.)

●

To restore the blinking LED during recordings, first press the

button once and enters into Menu mode. Then press the

button to return Measurement mode.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Sin comentarios

Kyoritsu 5020 Instruction Manual Manual de usuario Pagina 31