Kyoritsu 6305 Instruction Manual Manual de usuario descargar pdf (Pagina 30)

4.3 KEW6305

4.2 Setting procedure of each setting item

“ Setting 01” Wiring system

Following explains how to make settings for wiring system.

Select the appropriate wiring system according to the environment to be measured.

Setting item

1P2W(1ch) : Single-phase 2-wire (1ch)

1P2W(2ch) : Single-phase 2-wire (2ch)

1P2W(3ch) : Single-phase 2-wire (3ch)

1P3W : Single-phase 3-wire

3P3W : Three-phase 3-wire

3P3W3A : Three-phase 3-wire

3P4W : Three-phase 4-wire

Default value (or after system reset) 3P3W

* Two-wattmeter method should be used for measuring 3P3W that requires using two Clamp sensors.

* For measuring/ recording the voltage and current on each phase, select “3P3W3A” and use three

Clamp sensors.

1 Use the Cursor key on the selection screen, and select “Setting 01”.

2 Press the ENTER key to get the instrument into setting change mode.

3 Present setting (or default value: 3P3W) blinks. Select the appropriate wiring configuration with the

Cursor key, and then press the ENTER key after making necessary change.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 137 138

Sin comentarios

Kyoritsu 6305 Instruction Manual Manual de usuario Pagina 30