Kyoritsu 6305 Instruction Manual Manual de usuario descargar pdf (Pagina 75)

KEW6305 6.10

● Customizing

1 Press the ENTER key either on Screen 1 or 2, to enter into custom display mode.

2Parameter displayed in upper row {eg. initial value: Screen1/ V(Voltage), Screen 2/P(Active power) } will

flicker.

3 Select the row to be customized using the UP or DOWN cursor key and the parameter to be selected with

LEFT or RIGHT cursor key.

4 When customizing other rows, select the row and parameters in same way.

5 Select any parameter you want to display it at each row, and press the ENTER key.

Selecting row

Screen 1

Screen 2

Selecting parameters

NOTE

* “f” can be customized only at the upper row, and “In” can be displayed only at the middle row. (when wiring

configuration is three-phase 4-wire)

* On pressing the ENTER key whilst on Screen 3, the instrument will display Screen 1-A custom mode.

* Customizing cannot be done during an integration/ demand measurement whilst a survey is underway. This

applies also for integration/demand stand by mode.

* After system reset, start-up screen appears.

* Pressing the ESC key during custom display mode restores the original displayed parameters.

（In）

Screen 1 Middle

Screen 1 Upper

Screen 1 Lower

Screen 2 Middle

Screen 1 Upper

Screen 2 Lower

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 137 138

Sin comentarios

Kyoritsu 6305 Instruction Manual Manual de usuario Pagina 75